English
Proper care of arc flash coveralls is essential to maintain their protective performance. At DOMEX SAFETY, our CAT 2 arc flash coveralls, shirts, and pants are manufactured to meet EN 61482, NFPA 70E, and ASTM F1506 standards, and following correct washing and maintenance procedures ensures they continue to provide ATPV ≥ 8 cal/cm² protection over time.
Use Mild Detergents: Avoid bleach or fabric softeners, which can degrade flame-resistant fabrics.
Wash Separately: Wash FR garments separately from non-FR clothing to prevent contamination.
Temperature: Use warm water (typically 40°C / 104°F) unless the garment label specifies otherwise.
Gentle Cycle: Minimize mechanical stress to prevent weakening seams or fabric.
Air Drying Recommended: Hang garments to dry naturally when possible.
Tumble Dry Low: If using a dryer, select low heat to prevent damage to FR fibers.
Avoid Ironing: High heat from irons can reduce protective properties.
Regular Inspections: Check for tears, fraying, or signs of wear before each use.
Repair Carefully: Only use approved FR repair kits or consult the manufacturer.
Replace When Needed: Garments that are heavily worn, contaminated, or damaged should be replaced to maintain safety compliance.
At DOMEX SAFETY, our arc flash coveralls are designed for durability and ease of care. Following proper washing and maintenance ensures consistent protection and extended garment lifespan, keeping your team safe in demanding industrial environments.
Proper washing and maintenance of arc flash coveralls is critical for preserving arc flash protection and meeting safety standards. By following these guidelines, employers can ensure their workers remain protected while maximizing the lifespan of their PPE.
